Great Clock
From Thomas Jefferson Wiki
The Great Clock is mounted in the Entrance Hall and has a second face on the east front of the house.[1] The Entrance Hall face indicates the hours and minutes on a larger dial, and the seconds on a smaller one. It is powered by two sets of cannon-ball-like weights (eighteen pounds each), which drive its ticking and the striking of a gong on the roof. The weights are strung on ropes and descend in the corners of the room on either side of the clock, through holes in the floor to the cellar below. Jefferson placed labels next to the path of the ticking (or running) weights to indicate the days of the week. The clock was wound every Sunday with a crank-like key, and a folding ladder was made in the Monticello joinery for that task.
Jefferson began planning the Great Clock in 1792, while in Philadelphia. By the beginning of 1793, the clock had been completed to Jefferson’s specifications in Philadelphia by Peter Spurck, an apprentice to Robert Leslie, whose workmanship Jefferson found less than satisfactory. Jefferson wrote to Leslie in December 1793, "My great clock could not be made to go by Spruck. I ascribe it to the bungling manner in which he had made it. I was obliged to let him make the striking movement anew on the common plan, after which it went pretty well…"[2]
The clock was probably installed in Jefferson’s Philadelphia house at Gray’s Ferry before it was transported to Virginia.[3] It was brought to Monticello when Jefferson returned there in 1794, and he soon solicited clockworkers to undertake its repair. At this same time he finally procured a gong for use with the clock.
It was not until 1804, while president, that Jefferson ordered the weights for the clock from the Foxhall Foundry in Washington, D.C. In January of that year, Jefferson was first confronted with the fact that the length of the descent of the clock weights, which he planned to have enclosed in a box, was greater than the height of the Entrance Hall. In a letter to James Dinsmore Jefferson arrived at the notable solution: "I do not approve of cutting the wall, not even the cellar wall to make a space for the descent of the clock weights, but would have them advanced into the room so as to descend clear even of the cellar wall. Should the box in this case encroach too much on the window we may avoid the eye sore by leaving them naked till they get to the floor where they may enter a square hole and go [on?] to the cellar floor..."[4]
The Great Clock has never been removed from Monticello since its installation in 1804-5.
Contents |
The Portico Clockface
In Jefferson's specifications for the Great Clock, Jefferson calls for two wheels which will "turn an hour hand on the reverse of the wall on a wooden hour plate of 12 I.[nches] radius."[5] He goes on to say "there need be no minute hand, as the hour figures will be 6 I.[nches] apart. But the interspace should be divided into quarters and 5. minutes marks. the fore & back hour plates will not be concentric."<ref.Ibid.</ref>
Thus the lack of a minute-hand is not a clockmaker's mistake but part of Jefferson's design. Because of the size of the face and the markings between the hour figures, the hour-hand itself would do the work of the minute-hand. The figure IIII is used on the clockface rather than IV. There are a couple of reasons behind this. First, It gives a better visual balance on the clock face. Second, IIII is actually how the Romans wrote 4. (The practice of using the subtractive forms of IV for 4 and Ix for 9, etc. did not develop until about 1300 AD.)
Primary Source References
1793. "...a toothed wheel of 2.I. [inches] on the back end of the axis of the hour hand…may turn an hour hand on the reverse face of the wall on a wooden hour plate of 12I. radius. There need be no minute hand, as the hour figures will be 6.I apart. But the interspace should be divided into [qu]artersand 5. minute marks."[6]
1793 April 27. "Pd R. Leslie for great clock."[7]
1795 May 23. (Jefferson to Archibald Stuart). "I think you have a watch and clock mender in Staunton. Does he ever pass this way? If he does, I should be glad he would call upon me to do a little work. I have a large clock for the top of my house which needs to be cleaned only and fixed up..."[8]
1853. (Benjamin Lossing). "Over the entrance door from the portico, is a large clock, placed there by Jefferson, which by an index upon the wall, indicated the days of the week. The weight which propels it is composed of nine eighteen pound cannon balls."[9]
1872. (David M.R. Culbreath). "...over the front door built into the wall is a good sized clock, which had to be wound standing upon a ladder--this latter being in normal position and claimed to have been made by Mr. Jefferson himself; the hands stand at 7.34 o'ck."[10]
1900. (Peter Fossett). "...As I entered the grand ballroom, there, above the door at the east, still stood the wonderful big clock, double-faced, with cannon balls of the Revolution for its weight. It marks the day of the week as well as the day time and its ponderous voice can be heard six miles away in the valley below. This Mr. Jefferson designed himself. And there, too, was the ladder he made--a folding one--to reach the lofty clock, and the big iron key he used to wind it with."[11]
Footnotes
- ↑ This section is from Susan Stein, Worlds, 376-377.
- ↑ PTJ, 27:508.
- ↑ Silvio Bedini, Thomas Jefferson, Clock Designer
- ↑ Thomas Jefferson to James Dinsmore, 28 January 1804. transcription from Sotheby's catalogue, Printed and Manuscript Americana, 26 January 1983.
- ↑ Library of Congress. http://www.loc.gov/
- ↑ Library of Congress. http://www.loc.gov/
- ↑ MB, 2:893.
- ↑ PTJ, 28:351.
- ↑ Peterson, Visitors, 141.
- ↑ Ibid, 152.
- ↑ Published in a Cincinnati newspaper, circa July 1900.
Further Sources
- Flash video of the Great Clock showing the striking of its gong from the Monticello Explorer [1]
